BETAFPV Lite Brushed Flight Controller

$11.99

KEY FEATURES

  • The world's first FC board compatible with Silverware firmware. This must be the most simple and affordable method to try whoop FPV racing hobby.
  • Support level mode and acro mode. Also it has the ability to change settings for custom builds, or to adapt to personal preferences by stick gestures.
  • Designed to work with current Tiny Whoop or Blade Inductrix frames
  • The flight controller board comes pre-flashed with Silverware firmware, and pre-soldered 55mm power cable pigtail with JST-PH 2.0 connector, AKA PowerWhoop connector.

SPECIFICATIONS

  • CPU: STM32F030
  • Six-Axis: MPU6050
  • ESC: All FETs are rated at 6.3A maximum. Support 6x15mm/7x20mm/8x20mm/8.5x20mm etc motors.
  • Size: 26mm x 26mm, fully compatible with the Inductrix quad frame and mounting pattern
  • Firmware version: Silverware firmware
  • Receiver: Bayang protocol
  • Power Cable: 55mm, with JST-PH 2.0 connector, AKA PowerWhoop connector
  • Weight: 2.5g 

SILVERWARE

Silverware is a firmware for some micro quadcopters, which support level mode and acro mode. So you could use this on whoop FPV racing. Also it has the ability to change settings for custom builds, or to adapt to personal preferences. 

By default, Silverware use stick sequences, which also called gestures, to change modes, tune PIDs, calibrate accelerometer or save settings.

For example, with Frsky QX7 radio transmitter, change the FC's mode between level and acro. Just move the right stick as show below.

STATUS LED

This board has 2 LEDs to indicate the status, including red LED ( at the front) and blue LED ( at the rear) . 

LED

Status

Description

Both

Flashing slow at the same time

Binding status

Both

Solid

Connected

Both

Flashing quickly and then be solid

Mode changed

 

Some pilots would complaint that it is definitely not a long range FC. It looses signal with my transmitter far too often and for what appears to be no reason. This issue is often caused by the location of the antenna. You should keep the antenna away from the FC board to get a stronger signal. For example, run the singal upwards.

PACKAGE

  • 1 * BETAFPV Lite brushed flight controller V1.0 ( 55mm PH-JST 2.0 power cable soldered)
  • 4 * M1.2x4mm screws (Fit for stock Inductrix frame)
  • 4 * M1.4x5mm screws (Fit for Beta75 etc 75mm frame)
  • 4 * Anti-vibration ruber dampers

You recently viewed

Clear recently viewed