F4 2S AIO Brushless Flight Controller 5A OSD Frsky

$49.99

SPECIFICATIONS OF FC

  • CPU: STM32F411CEU6 (100MHZ )
  • Six-Axis: MPU-6000 triaxial accelerometer / triaxial gyroscope (SPI connection)
  • Size: 26mm x 26mm, fully compatible with the all whoop drone mounting pattern, recommend the Beta65X frame and Beta75 Pro frame.
  • Firmware version: betaflight_matekf411rx_4.0.0 (Development Version)
  • OSD: Built-in BetaFlight OSD (STM32 controls OSD chip over SPI in DMA mode)
  • Built in SPI Frsky D16 protocol native receiver, compatible with almost ALL Frsky FCC radios(e.g. Taranis X9D/X9D Plus/X7) or Frsky compatible transmitter module. Not compatible with Frsky LBT protocol.
  • Power Cable: 55mm, with 2pcs JST-PH 2.0 connector, AKA PowerWhoop connector
  • Weight: 4.5g 

DIAGRAM FOR F4 2S AIO FC (BUILT-IN FRSKY RX)

       

    SPECIFICATIONS OF ESC

    • Built-in ESC with 5A continuous and peak 6A current
    • Power supply: 1-2S
    • Support BLHeliSuite programmable
    • Factory firmware: S_H_50_REV16_7.HEX
    • Signal Support: D-shot150, D-shot300, D-shot600, Oneshot125, Multishot, PWM

    Status LED

    There are 3 LEDs on the bottom of the board to indicate the status, including Receiver LED ( Green), FC Status LED ( Red ) and FC Power LED ( Blue ). 

    LED

    Status

    Description

    Receiver LED ( Green)

    Solid

    Connected or in bind mode

    Receiver LED ( Green)

    Flashing

    Not connected

    Power LED ( Blue )

    Solid

    Power on

    Status LED ( Red )

    Solid

    Motor Armed

    SPI Frsky Receiver

    Currently the built in Frsky receiver is compatible with Taranis, Taranis Plus, X9E, Horus X12S, XJT Modules. Pay attention, this is a SPI connection receiver. In Betaflight Configuration, it should be setted as FRSKY_D receiver (aka Frsky D8 mode) or FRSKY_X receiver (aka Frsky D16 mode) in SPI RX mode.

     

    The Frsky D16 unstable connection issue is totally resolved since Betaflight 3.4.1. Nowadays, the default configuration from factory is Frsky D16 mode (FRSKY_X).

    Note: If you are using EU-LBT firmware radio controller, you might find that you can't bind successfully to this SPI Frsky receiver. Here are the solutions we provide for you. Thanks to Sebastian Abramowski for giving us the important feedback about binding to EU-LBT firmware radio controller. 

    You recently viewed

    Clear recently viewed