Ready to Fly QAV-PIKO Micro Kit

Save $36.66

QAV-PIKO 2" Micro Quadcopter (2s-3s)

The QAV-PIKO 2" Micro FPV Quadcopter is a true x micro FPV frame. It was built using premium Lumenier carbon fiber that is super smooth and will take a beating. The frame focuses on symmetry and the QAV-PIKO takes advantage of this by using a standard 20x20 stack as part of the frame structure. This results in an ultralight, very clean and simple build! The kit comes with a 30cm long silicone tube that is meant to be cut into standoffs. The silicone serves two purposes, one, you are able to cut them to the exact height you want, and two, they serve as a "soft mount" for your electronics, giving you less vibration to your FC.

The frame features a solid 2mm thick main plate and 1.5mm top plate and side plates to protect your FPV camera. The side plates slip into slots on the top plate for a press fit while the included long screws will thread all the way through the main plate through your FC and ESC stack, to the top plate.

The PIKO 2" was designed to work with FPV Micro Camera / VTX combos. The camera has a built-in VTX and is able to be tilted to any angle because of the way it is mounted to the frame. Apply the included rubber side wall adhesives to the verticle side plates and the camera fits snugly in place. You can also use different FPV cameras, but you may have to add / remove foam/rubber to mount it just the way you want it.

The QAV-PIKO mounts batteries on the bottom and comes with a LiPo pad and a rubber band to secure your battery to the bottom of the quad. The kit also comes with an XT-30 cable so you can use your high powered batteries.

The QAV-PIKO 2" is able to run up to 2" props to give you some insane thrust for something this small.

T-Motor F10 1104 7500KV Motor

The Tiger Motor F10 series may be small in size, but they are large in power! With the micro class growing in the FPV world, TMotor couldn't resist making their own micro motor.

Matek F405-MINI Flight Controller w/ F405, 32k Gyro, BFOSD, 32M Flash

Matek has miniaturized their already very popular F405 AIO Flight Controller. The F405 Mini was designed to be smaller and lighter than its bigger brother, and the 20x20mm mount allows for more space to work with on your build. 

Racerstar Tattoo_S Mini 12AX4 12A STM32F051 BLheli_32

Con. Current: 12A
Peak Current(10s): 16A
Chip: ST/ARM

Lipo: 2-4S


BS2 Cmos AIO FPV Camera with OSD interface



RF Module:  Multi-Protocol Module Compatible Single chip (CC2500)

Size:  160*130*60mm

Weight:  266g

Frequency:  2.400GHZ-2.480GHZ

RF Module:  Multi-Protocol Module Compatible Single chip (CC2500)

Protocol Options:  All CC2500 – Frsky, S-FHSS, RadioLink, Graupner HoTT and more*

Transmission power:  20dbm

Antenna gain: 2db

Range:  > 1km @ 20dbm (depending on the receiver)

Battery:  Built in 3.7v 1000mah Lithium battery

Charging:  Built in USB-C charging

Firmware:  OpenTX - Multiprotocol-TX-Module

Channels:  Up to 16 channels (depending on the model / receiver)

Screen:  Clip on 128x64 LCD and OpenTX control module

Gimbal:  High-precision quad ball bearing HALL Sensor gimbal

Voice support:  Yes (SD Card required)



You recently viewed

Clear recently viewed